MachoPowerWagon.com
http://machopowerwagon.com/phpBB3/

Rear sway bar install on '93 Cummins
http://machopowerwagon.com/phpBB3/viewtopic.php?f=27&t=1208		 Page 1 of 1
Author:  jimbob [ Tue Nov 09, 2010 2:41 pm ]
Post subject:  Rear sway bar install on '93 Cummins
Finally waited long enough, ordered and installed one of those Hellwig rear sway bars that Sam told me about. Installed on a '92 W250 Cummins. Easy install, 1 1/2hr-2hrs. No drilling. About the same diameter as the front, 1 1/8" dia. We'll see how it works out this week! Would most likely work on the 1/2tons also, IF you have a front one on there too. Take a look. And if you had a lift, I think you could extend the end links. Bigger than those ones I see on the new factory Phords..

-Jim

Attachments:
rear_swaybar_2.jpg
rear_swaybar_2.jpg [ 108.8 KiB | Viewed 2996 times ]
rear_swaybar_1.jpg
rear_swaybar_1.jpg [ 118.39 KiB | Viewed 2996 times ]
Author:  RumbleFish [ Tue Nov 09, 2010 4:15 pm ]
Post subject:  Re: Rear sway bar install on '93 Cummins
should be a nice little upgrade. mt D350 had a dana 80 swapped in, but also had the attatched sway bar. i could definitely tell a difference over my last dually.
Author:  jimbob [ Wed Nov 10, 2010 10:29 pm ]
Post subject:  Re: Rear sway bar install on '93 Cummins
Ya, it's a GREAT upgrade. I worked 200 miles of mountain roads with it today, it's little different getting used to no body roll! Have 4 rigs to haul this week so we'll have to see how well it works with the load too. I'd recommend them, they're on sale, and also $20 off promo deal, pays for shipping!

-Jim
Author:  jimbob [ Fri Nov 12, 2010 2:35 am ]
Post subject:  Re: Rear sway bar install on '93 Cummins
Hauled two rigs today with that cummins with new rear sway bar installed. Handles super nice! I recommend it! Makes we want to drive fasterrrrr.... ! : D

-Jim
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/