MachoPowerWagon.com http://machopowerwagon.com/phpBB3/ |
|
Roll Bar http://machopowerwagon.com/phpBB3/viewtopic.php?f=6&t=640 |
Page 1 of 1 |
Author: | dodgebee [ Thu Nov 26, 2009 12:31 am ] |
Post subject: | Roll Bar |
Looking for a roll bar for my 79. The catch is that the roll bar has to fit a short box STEP-SIDE box!!! Still looking for 15 x 12 western turbines half ton. Thanks dodgebee@mchsi.com |
Author: | LAST440 [ Thu Nov 26, 2009 12:54 pm ] |
Post subject: | Re: Roll Bar |
Here's a sad little story. Not sure if it sad because it's true, or because of what I almost did. I was in the over congested land of little cars and crazy drivers, to get a pickup bed. Had my dually and car hauler. My lights on my trailer were non-op and I was trying to get before dark. Pulled into a shopping center to grab some chow and could not find a single, (double) place to park. I went to pull out and get back on the freeway, only to find 8 million other fools trying to do the same thing. Lunch time. I finally got into 1 of two exit turn lanes back to the avenue, then hopefully be in the correct lane for the on ramp, and that after going thru three lights and not getting stuck in an intersection with my tail hanging out. What a mess. But........ As the lane next to me edged up, I could see a landcaping truck with rakes and mowers and stuff. And as it edged further along side me I could see all the Garbage form the yard they must have hust cleaned up. Piled high in the dump trailer they were towing. I knew it was all going to the trash. Brush, broken toys, garbage. On top of it all. 4 tires and rims. Tires were big, like for a 4x4, but junk. But the rims.... One of the nicer sets of aluminum aftermkt turbines I've seen. Probably 15x10s. Just wasn't a thing I could do. So I just watched, as they inched forward. All going for their last drive |
Author: | 1Ton Macho [ Fri Nov 27, 2009 3:30 pm ] | ||
Post subject: | Re: Roll Bar | ||
I'm not sure what Western Turbines are but when ever I hear that word I think of these aluminum wheels. http://milwaukee.craigslist.org/pts/1446578789.html
|
Author: | dodgebee [ Fri Nov 27, 2009 7:40 pm ] |
Post subject: | Re: Roll Bar |
Bolt pattern for the rims are the 79 and older bolt pattern. |
Author: | RumbleFish [ Sun Nov 29, 2009 2:57 pm ] |
Post subject: | Re: Roll Bar |
the wheels in the pic look like the factory 80's turbine wheels minus the centers. similar, but the spokes are different. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |